Overview
Please Note: Please measure the lower unit of your motor before purchase. Direct any questions to Motormate customer service: 1-844-668-6768
Your outboard motor is a major investment, and protecting it while transporting it to the water should be a top priority. The Motormate Johnson/Evinrude Locking System locks most Johnson & Evinrude 2-Stroke outboard motors in place, preventing costly damage to your steering system and excess torque on your transom. The Motormate Locking System also releases pressure off your hydraulic system.
Guy Eakers, Ott Defoe, Bryan Thrift, Randall Tharp, Aaron Martens, Timmy Horton and Jason Christies are just a few of the Elite Series and FLW pro’s who rely on Motormate Locking Systems to protect their motors and transoms when traveling across the Country.
Johnson/Evinrude 2-Stroke Model #101 - Fits 2-stroke motors, 85HP-250HP motors. Fits most years 1991-2010.
Johnson/Evinrude E-TEC G2 Model #102 - Fits Evinrude E-TEC G2 225-300hp & 200-250hp HO Motors
Model | Yoke | Transom Mount |
#101 | 4-1/2" | 6-1/4" |
#102 | 7-1/2" | 6-1/4" |
Yoke Dimensions - Measured from center to center of Motormate prongs. Span the distance between the motor contact points, securing the Motormate to the motor drive shaft housing.
Transom Mount Dimensions - Measured from the inside edges of the stern brackets.
Previous Feedback
Comments: Have one for Evinrude G2 225 hp... after 3 years and moderate travel, saver is not useable. It continues to bend at the curve on the unit. Worth 135.00? Not... any better choices for a G2? Probably not...
From: Unknown: 3/13/21
Comments: Same problem as Ed below. Used it only one week last year. Went to use it this year for our spring trip and one of the grips had sheared off. I noticed they weren't welded on either but were applied to the sliding bar using another method. Cheaply done. And non replaceable by Tacklewarehouse standards.
From: Jonathon: Kingsport, TN 3/10/21
Comments: Cheaply made for what you pay but seems to work.
From: Jethro: Maryland 3/8/21
Comments: Works great until the (2) extending rods shear off! -Lasted 2 years They're probably using Chinese Steel.
From: Ed: Fremont, California 7/29/18
Comments: One of the best motor locking products out there. Holds your motor rock solid, however do not expect the powdercoating to last very long, I am on my second one and both started chipping after 2 trips. Outside of the Powdercoat issues this is a must have product.
From: Unknown: 5/21/18