The Ram-Mount D111UC Marine Electronics Mount consists of a short double socket arm, 3.68" diameter round base and 11" x 3" rectangular base. The round base contains pre-drilled holes, including two holes at 180-degrees and three holes at 120 degrees. The rectangle base contains different combinations of pre-drilled holes which will match up to many electronic devices and mounts, including Marine GPS, CB Radios, Ham Radios, Gimbal Brackets and more. The rubber D-size ball measures 2.25" in diameter. Extremely durable, the Ram-Mount D111UC Marine Electronics Mount is constructed from powder-coated marine-grade aluminum.
The RAM-D-111U-C is Compatible With:
-Garmin Fishfinders and GPS Chartplotters
-Humminbird Fishfinders and GPS Chartplotters
-Lowrance Fishfinders and GPS Chartplotters
-Raymarine Fishfinders and GPS Chartplotters
Comments: This mount does not fit the Gimbal mount with the HDS- Gen2 as stated from KS. I had to drill some new holes into the Gimbal mount and the Ram Mount to make it fit. Overall very sturdy mount and pretty awesome, only drawback is with all those existing holes on the Ram Mount make it fit with the Lowrance Gen 2 equipment.
From: Travis: USA
Comments: This Ram-Mount doesn't fit the gimbal bracket that comes with the Lowrance HDS-8 Gen 2. I tried for hours to find some way to get them to mount, but there was no way to align more than two of the holes. Either my HDS-8 Gimbal had incorrect holes pre-drilled, or the Ram-Mount did. I am still going to save the Ram-Mount and use it next year for an HDS-10 upgrade and hopefully THAT fits.
From: KS, USA
Comments: By far the only way to mount a fishfinder, i have mine in an hds-10 and a hds-7 both are rock solid in evan the most rough waves. dont chince out when those units cost so much, you'll be glad when u buy it!
From: Joe: Lake Orion, MI
***Note: If you have questions about this product or need assistance with an order please email your questions to firstname.lastname@example.org