Overview
Designed to fit all cable-and-steer bow mount Minn Kota trolling motors, the Minn Kota Replacement Cable & Handle provides a dependable and ergonomic replacement for your trolling motor. Constructed using durable, braided stainless steel, the Minn Kota Replacement Cable and Handle features a contoured, soft touch handle that makes it easy to lift your motor in-and-out of the water.
Offered in a standard 42-inch length, the Minn Kota Replacement Cable & Handle is covered with an abrasion-resistant nylon coating that permits use in saltwater. Easy-to-install, the Minn Kota Replacement Cable & Handle is perfect for stashing in the boat as a replacement - just in case.
--------
Please Note: This product is not available for order outside of the United States.
Previous Feedback
Comments: For me, very difficult to install. I'm going to have just get another rope so I can tie it. My Edge design has a solid bar that makes it very hard.
From: Leon: 12/13/19
Comments: Replaced the original pull cord with this upgrade, should have done it sooner. Good product.
From: Clark: Houston, TX 2/16/18
Comments: Bought one to replace the rope before I had issues with the rope breaking. The cable pulled out of the handle when I got stuck in the sand. Pretty disappointed in the design especially when the cost of this was significantly higher than others that had a much better handle to eliminate this issue. Now use the G Force red handle and love it.
From: Unknonwn 2/11/18
Comments: I have a Minn Kota Maxxum & have tried the T&H Marine & the Viking and both of them failed but this one is the best so far!!
From: Brian: Burlington, NC 6/7/15