Overview
This spooler assistant from the makers of P-Line is perfect for those times when you need a quick refill or you need to spool all your rods. The lower section has a suction cup that will stick to the side of your boat or your work bench. This assistant will fit up to 1/4lb spools. The tension can be adjusted so you can make sure your line is always tight. This is a great item to have one in the boat and one at home.
Videos
More From P-Line
Customer Reviews
PJ-Line Fishing Line Spooler AssistantI remove the suction cup and mount the frame to my work shop vise. All my replacement line spools are 300 yards. BTW, for baitcasters the line comes off at the top of the replacement line spool, for spinning reels, line comes off at the bottom. This unit works well and not expensive.
not impressedby eye, it looks like a good idea. however, the suction cup doesn't stick to anything for more than a couple minutes before it lets go. also, i have 1000 yrd spool of 12 lb pline flouro, it doesn't fit unless you don't use the springs, and leave off one of the locking bearings. luckily it was cheap, so i'm not out much money.
Previous Feedback
Comments: Simple and works great does spinning reels also. No issues
From: Jason: Royse City TX 2/25/23
Comments: This works well, but I do have to remove the suction cup and mount to my vise, and it does spinning reels too
From: Frank: Ontario, Canada 10/20/21
Comments: I got this & found it had a problem. The suction cup & rod hole connect did not match up. I wrote the company a hand written letter about the problem & no response. The suction cup is strong the springs & guides are well made. It will stay together somewhat with the miss alignment. It doesn't hold the large spools very well. Its useable but I would not buy again.
From: Brad: Jackson, IN 9/2/21
Comments: Simple and works great. I open my live wells and stick it to the smooth fiberglass divider. I can then sit on the front deck and re-spool. Add a Line Dr style Band on your spool and no more line wrapped around the spring.
From: Brian: Pleasanton, CA 7/12/20
Comments: This works great. Stick it to the back glass of your pickup and you're golden! I got mine to stick to my tailgate as well. You can even get it to stick to your fiberglass boat if it is as smooth as my Ranger gel coat. Works great! Put the spool of line in the vertical position for baitcasting reels and horizontal position for spinning reels.
From: Joey: Illinois 1/27/17
Comments: Needs a very smooth surface to stick, granite/marble/glass counter-tops would work well. I re-line in my garage so i have my jewelers anvil held to my workbench, with a clamp, with this suctioned to it. Make sure the nut on the base is tight or the armature will move. IMPORTANT the positioning of this is intended for baitcasters. To spool spinning reels you will want the spool facing vertically. Just chuck this in a vise with the arm pointing up and your good to go.
From: Joe: Abington, MA 8/6/16
Comments: I cant seem to stick this thing anywhere. it stays stuck for about 5 reels of the handle then its unstuck
From: Mike: MA 7/24/16
Comments: Works great. Will sometimes wrap around spring but as long as you keep tension it works fine. Keeps good tension while spooling and suction cup holds firmly. It can hold the larger 12#/1000yd spools too.
From: HmoobYaj