Overview
The Sea Clear Power Wiring Harness with Switch & Jumper is the first wiring harness ever made for the sole purpose of wiring up all of your marine electronics. Tired of poor image quality? Tired of your units blinking? Tired of your units and accessories not being on one system? Tired of waiting on your units taking 30 seconds to start reading structure scan after coming off pad? Pick up a Sea Clear Power Wiring Harness with Switch & Jumper today to solve all these problems with clean power and "sea" the difference.
Compatible with all brands and accessories including Humminbird, Garmin, and Lowrance, the Sea Clear wiring system allows you to tie all of your graphs and electronics into one harness. You will need to purchase fuse holders to complete installation. Ttypically you will need one (1) fuse holder for every electronic device you add to the circuit. To get the highest performance, Sea Clear recommends using the Sea Clear Inline Corrosion Resistant Fuse Holders, so every processor on your boat gets the clean and adequate power it needs to work properly. Check out the Sea Clear Power Wiring Harness with Switch & Jumper Install Walkthrough in the Product Video section for a full installation breakdown.
Included:
- 26-ft Universal Harness
- Battery Disconnect Switch
- 20-in Jumper Wire
Please Note: You will need to purchase fuse holders to complete installation. Typically you will need one (1) fuse holder for every electronic device you add to the circuit. Sea Clear recommends using the Sea Clear Inline Corrosion Resistant Fuse Holders to ensure clean and adequate power to all processors.
Backed by Sea Clear Power’s Warranty
All warranties must go directly through Sea Clear Power.
Previous Feedback
Comments: Connectors are junk. Switched to sonarpros harness on my new boat and have better results and more confidence in my system.
From: Craig : TN 3/24/23
Comments: GAME CHANGER for my graphs, Active Target, AND batteries!!! I had 10ga wire installed straight from the battery when I purchased my boat and it worked pretty good. After finally being convinced that wiring was what was causing the interference I was seeing on my screens. This harness eliminated the interference....crystal clear now.
From: Brian: TX 1/23/23
Comments: Although this harness uses quality material and connections the price is absolutely outrageous. You can find these materials online and build it yourself for fraction of the cost. In my opinion a marketing scam
From: Andrew: CA 10/25/22
Comments: Powering your units with the Sea Clear wiring harness is the only way to go. I had an install done by a reputable company but noticed my units losing power halfway through a tournament. I thought it was the batteries so I replaced them. Still had the same issue. I later found a YouTube video by Sea Clear so I figured I would try it. I contacted them and was greeted with very helpful staff and great customer service. The install was easy taking about 2 hours, only because I'm meticulous on routing my wires and securing them. Once on the water, we noticed the huge improvement to the quality of our displays. A few weeks later we put them to the test by fishing a 9 hour tournament. We didn't have one issue. The units stayed bright, clear, and glitch free.
Sea Clear makes a great product. You will not regret this purchase.
From: Dustin: Unknown 8/13/21
Comments: Love mine, went from getting down to 11.9v to 10.9v at the end of a fishing day before the harness to 12.4v + the entire day with the harness. I'll definitely be having one installed on my 2022 rig when it arrives!
From: Brad: Louisville, KY 3/28/21